Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Long Range Hunting & Shooting
Accuracy Issues with "turn key" 1000yd rifle
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Wyowelder" data-source="post: 1681144" data-attributes="member: 100913"><p>Hello everyone, longtime follower but this is one of my first time posts. Last fall my wife purchased me a custom long range rifle that was set up with optics ready to go (wont name them yet, hope they make things right) and I can't seem to get it to shoot less than a 3 to 4 inch 3 shot group at 100 and 200 yards with their provided load[ATTACH]142951[/ATTACH] [ATTACH]142952[/ATTACH] [ATTACH]142953[/ATTACH] . After checking the usual, scope mounts, action screws, shooting it clean, fouled etc. I found about a 2" crack in the synthetic stock in the top of the grip behind the back tang . It looks like it's the seam where the two molds came together. After noticing the crack I pulled the action out of the stock and found that it is not bedded, just a bedding block and it looks like the action has been able to move from the markings. What are your thoughts?</p></blockquote><p></p>
[QUOTE="Wyowelder, post: 1681144, member: 100913"] Hello everyone, longtime follower but this is one of my first time posts. Last fall my wife purchased me a custom long range rifle that was set up with optics ready to go (wont name them yet, hope they make things right) and I can't seem to get it to shoot less than a 3 to 4 inch 3 shot group at 100 and 200 yards with their provided load[ATTACH]142951[/ATTACH] [ATTACH]142952[/ATTACH] [ATTACH]142953[/ATTACH] . After checking the usual, scope mounts, action screws, shooting it clean, fouled etc. I found about a 2" crack in the synthetic stock in the top of the grip behind the back tang . It looks like it's the seam where the two molds came together. After noticing the crack I pulled the action out of the stock and found that it is not bedded, just a bedding block and it looks like the action has been able to move from the markings. What are your thoughts? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Long Range Hunting & Shooting
Accuracy Issues with "turn key" 1000yd rifle
Top