Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Long Range Hunting & Shooting
7mm Blaser Mag experience?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="gunnar andersen" data-source="post: 1338113" data-attributes="member: 99774"><p>Midnight, I just caught on to this thread today and read with interest. I did have a 7 mm Blaser made up 3 years ago, it was to replace a 7x61 so used the S&L action M65. </p><p>Dies at that time was available from CH, I also bought a Body die so I could use it with the CH neck Bushing die. The Chamber reamer was supplied by PTG. Both chamber and resizing dies are within CIP spec.(but the tolerance here is quit large).</p><p> Unfired brass I meassured to hold 81.7 gr, Fired 83.7, and Re-sized 83.0 gr. Ideally would be to have a die made up to "fit" the chamber, I think I then could double the times of reloads, I average 12 re-loads from a case, and what I read here, my load is mild. I tried MRP, H4831sc, 7828, 7977, Magpro, but finaly settle with Re 26 68.2 gr this give me 3050 ft/s using the Nosler Partition 160 gr. 26" barrel.</p><p> I'm interested to hear if any have chamber reamer made by Dave Mason or other reamer co. Gunnar BC</p></blockquote><p></p>
[QUOTE="gunnar andersen, post: 1338113, member: 99774"] Midnight, I just caught on to this thread today and read with interest. I did have a 7 mm Blaser made up 3 years ago, it was to replace a 7x61 so used the S&L action M65. Dies at that time was available from CH, I also bought a Body die so I could use it with the CH neck Bushing die. The Chamber reamer was supplied by PTG. Both chamber and resizing dies are within CIP spec.(but the tolerance here is quit large). Unfired brass I meassured to hold 81.7 gr, Fired 83.7, and Re-sized 83.0 gr. Ideally would be to have a die made up to "fit" the chamber, I think I then could double the times of reloads, I average 12 re-loads from a case, and what I read here, my load is mild. I tried MRP, H4831sc, 7828, 7977, Magpro, but finaly settle with Re 26 68.2 gr this give me 3050 ft/s using the Nosler Partition 160 gr. 26" barrel. I'm interested to hear if any have chamber reamer made by Dave Mason or other reamer co. Gunnar BC [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Long Range Hunting & Shooting
7mm Blaser Mag experience?
Top