7mm Accubond Load

Discussion in 'Reloading' started by PaHitman, Feb 19, 2006.

  1. PaHitman

    PaHitman New Member

    Messages:
    2
    Joined:
    Dec 20, 2005
    Anyone care to post up a load for 7mm Rem Mag. with 140gr. accubonds? Thanks.
     
  2. firstcoueswas80

    firstcoueswas80 Well-Known Member

    Messages:
    336
    Joined:
    Jan 4, 2006
    the tighest group from my 7mag with out tuning the load was 65 grains of r22 with the 140 NAB. lit by F215M primers, in winchester brass. i have not tuned this load or played with the over all lenght but it shot a .956 out of a stock remington... heavy trigger pull and non-floated barrel.
     

  3. sewwhat89

    sewwhat89 Well-Known Member

    Messages:
    773
    Joined:
    Jul 26, 2005
    The best I've shot was 67 gr RL 19. I am not sure about the velocity, but out of a 24" barrel I think it was 3120-3140. Shot about 0.7MOA out to 200m when we tested it.
     
  4. keithcandler

    keithcandler Well-Known Member

    Messages:
    187
    Joined:
    Jan 30, 2005
    I have two loads:
    Rem brass
    9 1/2
    65.0g of IMR 4350
    140g Accubond seated to touch the lands
    groups with the bullets touching at 3250

    Rem Brass
    9 1/2
    64.5g of H-4350
    140g Accubond
    Bullets seated to touch the lands
    3200 fps bullets touching at 100 yards

    Please don't change the brand of brass or primer in the above loads...groups go to crap if you do!

    Rifles and of course lot# of powders do change, so I'd back off a grain and work up to these loads.

    Good luck!
     
  5. Ol'Gator

    Ol'Gator Well-Known Member

    Messages:
    148
    Joined:
    Dec 15, 2005
    I'm still tweaking but as of now:

    Fed brass
    Fed 215M Primers
    63.8 Gr. IMR 4350
    140 Gr AB
    .005 off lands
    .5" @ 100 yds.

    I've tried this combo several trips to the range and keep repeating. Gonna play with seating depth some today.