Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7mm-300wsm reloading
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="21buck" data-source="post: 400910" data-attributes="member: 12241"><p>mw185, Use the full length die to resize the 300 wsm to a 7mm. Lube it properly and run it thru the die. There are no other items necessary.</p><p></p><p>You could anneal the neck and shoulders before you load them. Make sure that the length is correct. and you are good to go for the first firing.</p><p></p><p>Second loading, I extend the expander and primer pin a bit farther down. What you want is the die to engage enough to pop the primer out and resize the top of the neck , not the entire body of the case. Take your time and it will work out easily. You do not want to extend the expander and primer remover too far. Be careful in your adjustment . Check case length.</p><p></p><p>When do you resize full length? Normally after 4-6 reloads and always with brass to be used on hunting trips. This is important that the cartridges feed smoothly and effectively.</p></blockquote><p></p>
[QUOTE="21buck, post: 400910, member: 12241"] mw185, Use the full length die to resize the 300 wsm to a 7mm. Lube it properly and run it thru the die. There are no other items necessary. You could anneal the neck and shoulders before you load them. Make sure that the length is correct. and you are good to go for the first firing. Second loading, I extend the expander and primer pin a bit farther down. What you want is the die to engage enough to pop the primer out and resize the top of the neck , not the entire body of the case. Take your time and it will work out easily. You do not want to extend the expander and primer remover too far. Be careful in your adjustment . Check case length. When do you resize full length? Normally after 4-6 reloads and always with brass to be used on hunting trips. This is important that the cartridges feed smoothly and effectively. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7mm-300wsm reloading
Top