Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
700 Bolt Extraction Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Timnterra" data-source="post: 2237417" data-attributes="member: 55944"><p>Primary extraction is not used unless the round is fired and the case swells tightly into the chamber it will not cause a failure to extract on an unfired round. The problem sounds like bad headspace if the sons bolt will also not pick up the round to extract it. Unless I missed it there has been no mention of if this was a take off another rifle or prefit barrel with a barrel nut. The op said it was headspaced correctly but the question must now be how did you set headspace and determine it was correct?</p></blockquote><p></p>
[QUOTE="Timnterra, post: 2237417, member: 55944"] Primary extraction is not used unless the round is fired and the case swells tightly into the chamber it will not cause a failure to extract on an unfired round. The problem sounds like bad headspace if the sons bolt will also not pick up the round to extract it. Unless I missed it there has been no mention of if this was a take off another rifle or prefit barrel with a barrel nut. The op said it was headspaced correctly but the question must now be how did you set headspace and determine it was correct? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
700 Bolt Extraction Problem
Top