Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
700 Barrel Removal at Standstill
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="rakkikoira" data-source="post: 2141631" data-attributes="member: 88937"><p>Looking at the photo of the the clamp, would there have been less compression of the clamp if the barrel had been clamped end-grain on rather than cross-grain. Look at old factory floors, many were build of end grain blocks that never showed wear from rolling equipment after a hundred years.</p></blockquote><p></p>
[QUOTE="rakkikoira, post: 2141631, member: 88937"] Looking at the photo of the the clamp, would there have been less compression of the clamp if the barrel had been clamped end-grain on rather than cross-grain. Look at old factory floors, many were build of end grain blocks that never showed wear from rolling equipment after a hundred years. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
700 Barrel Removal at Standstill
Top