Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7/300WSM Case Capacity and Forming
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="300magman" data-source="post: 517929" data-attributes="member: 24769"><p>I am just curious what the typical case capacity is for the 7/300WSM wildcat. </p><p> </p><p>I have been thinking about a 7mm SAUM, but if the 7/300 falls about halfway between the SAUM and the straight 7mm WSM I just might give it a try....assuming case forming isn't too much of a challenge. </p><p> </p><p>Can I just bump the necks down in one step, run a 7mm expander ball through them, and then neck turn to fit my chamber?</p></blockquote><p></p>
[QUOTE="300magman, post: 517929, member: 24769"] I am just curious what the typical case capacity is for the 7/300WSM wildcat. I have been thinking about a 7mm SAUM, but if the 7/300 falls about halfway between the SAUM and the straight 7mm WSM I just might give it a try....assuming case forming isn't too much of a challenge. Can I just bump the necks down in one step, run a 7mm expander ball through them, and then neck turn to fit my chamber? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7/300WSM Case Capacity and Forming
Top