Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.5-300 wsm pressure signs
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="tyfo" data-source="post: 782174" data-attributes="member: 48854"><p>Hey everyone. I have a new 6.5-300 wsm and im getting some unclear pressure signs. i started with 5grs less than hodgdons recommended starting load for h1000 in a 270 wsm. after every shot i looked the case over for signs and saw nothing and there was no heavy bolt lift until i got way up there in powder. after i had deprimed the brass (none of the primers felt loose) and cleaned the cases i was inspecting them again and saw very faint ejector marks on every piece of brass. this is my first wsm and i know they run at high pressure so i was wondering if you guys think this is a high pressure issue even though i started so low with the charge or if it could be an issue with having softer brass in a higher pressure chambering. the brass is norma. thank you for the help.</p></blockquote><p></p>
[QUOTE="tyfo, post: 782174, member: 48854"] Hey everyone. I have a new 6.5-300 wsm and im getting some unclear pressure signs. i started with 5grs less than hodgdons recommended starting load for h1000 in a 270 wsm. after every shot i looked the case over for signs and saw nothing and there was no heavy bolt lift until i got way up there in powder. after i had deprimed the brass (none of the primers felt loose) and cleaned the cases i was inspecting them again and saw very faint ejector marks on every piece of brass. this is my first wsm and i know they run at high pressure so i was wondering if you guys think this is a high pressure issue even though i started so low with the charge or if it could be an issue with having softer brass in a higher pressure chambering. the brass is norma. thank you for the help. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.5-300 wsm pressure signs
Top