Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
338 RUM to 338 edge?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Ross Douglas" data-source="post: 1147180" data-attributes="member: 90129"><p>Do you know any good gun Smiths? I would like to get a PTG bolt to cut down on some of the slop. Not sure what brand of barrel I want. If I go with the .30 cal I want a 1/11 twist and throat for 190-210 VLD. Not sure how tight to make the neck. How much to: fit the bolt to the reciver, pin recoil lug to reciver, taper, cut flutes in the barrel, crown and barrel the action?</p></blockquote><p></p>
[QUOTE="Ross Douglas, post: 1147180, member: 90129"] Do you know any good gun Smiths? I would like to get a PTG bolt to cut down on some of the slop. Not sure what brand of barrel I want. If I go with the .30 cal I want a 1/11 twist and throat for 190-210 VLD. Not sure how tight to make the neck. How much to: fit the bolt to the reciver, pin recoil lug to reciver, taper, cut flutes in the barrel, crown and barrel the action? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
338 RUM to 338 edge?
Top