Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 Lapua - case expansion and sticky bolt ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="3006savage" data-source="post: 412344" data-attributes="member: 12069"><p>I would verify that you have adaquate room for neck expansion. If the reamer cut the area the outside of the case neck chambers too tight it can cause pressures to run high. I think you could neck turn a couple cases and fire them with the same powder charges you have been trying to see if the pressures drop. Also make sure your brass is trimmed to the right length and check your scale.</p></blockquote><p></p>
[QUOTE="3006savage, post: 412344, member: 12069"] I would verify that you have adaquate room for neck expansion. If the reamer cut the area the outside of the case neck chambers too tight it can cause pressures to run high. I think you could neck turn a couple cases and fire them with the same powder charges you have been trying to see if the pressures drop. Also make sure your brass is trimmed to the right length and check your scale. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 Lapua - case expansion and sticky bolt ?
Top