Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
338 Edge Repeater magazine help...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="djcompto" data-source="post: 546962" data-attributes="member: 3642"><p>It certainly is a learning experience for sure. Hopefully that bottom metal will be here Friday and I can start taking a look at what goes where. I certainly don't plan on being unsafe and was definitely aware of being careful working on that lower abtutment. After I get the bottom metal I can work on the rear of that receiver and then try and figure out exactly what I need on the front end. I don't plan on sacrificing integrity so whatever I end up with is what I'll have. A guy over on SavageShooters is helping too. He just modified his to run DBM and he has some mods to his lower front end. He just made a very small "V" to let the bullet tip through. To me, doesn't seem too drastic a reduction of material. Thanks for the help on my journey.</p><p></p><p>DC</p></blockquote><p></p>
[QUOTE="djcompto, post: 546962, member: 3642"] It certainly is a learning experience for sure. Hopefully that bottom metal will be here Friday and I can start taking a look at what goes where. I certainly don't plan on being unsafe and was definitely aware of being careful working on that lower abtutment. After I get the bottom metal I can work on the rear of that receiver and then try and figure out exactly what I need on the front end. I don't plan on sacrificing integrity so whatever I end up with is what I'll have. A guy over on SavageShooters is helping too. He just modified his to run DBM and he has some mods to his lower front end. He just made a very small "V" to let the bullet tip through. To me, doesn't seem too drastic a reduction of material. Thanks for the help on my journey. DC [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
338 Edge Repeater magazine help...
Top