I am making up some 338 EDGE loads for the first time.
I started with new Remington RUM brass then uniformed the Primer pockets and flashholes. I then and run them through a K & M mandrel to expand them to .338 cal and then neck turned them to .366"
These cases look ready to load but do I need to now run them through a .338 EDGE FLS die?
These cases are only to run the barrel in so I would like get away without Full length sizing them?
I started with new Remington RUM brass then uniformed the Primer pockets and flashholes. I then and run them through a K & M mandrel to expand them to .338 cal and then neck turned them to .366"
These cases look ready to load but do I need to now run them through a .338 EDGE FLS die?
These cases are only to run the barrel in so I would like get away without Full length sizing them?