Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300g berger hybrid oal issues
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="llklein" data-source="post: 546344" data-attributes="member: 34262"><p>we are using rcbs std dies.we pulled the seater out and polished it up a bit in the lathe after marking a bullet and sticking it in the seater i noticed it wasnt touching the bullet it the same place all the way around.its hitting the bullet about 3/16 up from the tip.but was quite abit higher one one side of the bullet then the other.after polishing it we had a nice clean line around the bullet .were going to try it again and if we still have issues im going to order the redding set up with the vld seater and the mic.</p><p> thanks for all the input.</p></blockquote><p></p>
[QUOTE="llklein, post: 546344, member: 34262"] we are using rcbs std dies.we pulled the seater out and polished it up a bit in the lathe after marking a bullet and sticking it in the seater i noticed it wasnt touching the bullet it the same place all the way around.its hitting the bullet about 3/16 up from the tip.but was quite abit higher one one side of the bullet then the other.after polishing it we had a nice clean line around the bullet .were going to try it again and if we still have issues im going to order the redding set up with the vld seater and the mic. thanks for all the input. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300g berger hybrid oal issues
Top