Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
280AI dies
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="pods8" data-source="post: 1015346" data-attributes="member: 83233"><p>I was planning to go FL dies and just setup to bump. I figure with the low body taper it wouldn't be a bad idea to resize each time to ensure good feeding (total personal thought, nothing technical behind that).</p><p></p><p>So out of curiosity why going with the traditional (which is only sorta standardized) now that a SAMMI spec has been laid down? I figure over time the new standard will become the prevalent one and there is nosler brass (and even ammo) available, dies are going to focus on the new SAMMI chamber, etc. Hopefully others enter the market on brass over time as well. Seems like chambering in the old one at this time is staying wildcat for no reason. [Though articals state when each is setup the same there is no difference in the end but the dies are still different which causes confusion to me still, either way I figure I might as well go with the "standard" for less headaches down the line.]</p></blockquote><p></p>
[QUOTE="pods8, post: 1015346, member: 83233"] I was planning to go FL dies and just setup to bump. I figure with the low body taper it wouldn't be a bad idea to resize each time to ensure good feeding (total personal thought, nothing technical behind that). So out of curiosity why going with the traditional (which is only sorta standardized) now that a SAMMI spec has been laid down? I figure over time the new standard will become the prevalent one and there is nosler brass (and even ammo) available, dies are going to focus on the new SAMMI chamber, etc. Hopefully others enter the market on brass over time as well. Seems like chambering in the old one at this time is staying wildcat for no reason. [Though articals state when each is setup the same there is no difference in the end but the dies are still different which causes confusion to me still, either way I figure I might as well go with the "standard" for less headaches down the line.] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
280AI dies
Top