Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
28 Nosler brass too tight after shooting
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Philward" data-source="post: 1842109" data-attributes="member: 92604"><p>Are you having trouble with cartridge entering chamber or the bullet into neck of case?</p><p></p><p>Went back and read original post again. So a fired nosler brass case will not allow a bullet to slide in neck prior to being resized. And the factory loaded ammo cases do allow a bullet to slide in the neck after being fired but prior to resizing. I read in another thread on here that nosler brass and factory loaded nosler ammo do not use the same brass, different volumes, so maybe just thicker brass than the loaded ammo is supplied with. Measure neck wall thickness? Were your loads beginning loads and thus low pressure? Lack of expansion maybe but just enough to send the bullet and the brass just shrunk back?</p></blockquote><p></p>
[QUOTE="Philward, post: 1842109, member: 92604"] Are you having trouble with cartridge entering chamber or the bullet into neck of case? Went back and read original post again. So a fired nosler brass case will not allow a bullet to slide in neck prior to being resized. And the factory loaded ammo cases do allow a bullet to slide in the neck after being fired but prior to resizing. I read in another thread on here that nosler brass and factory loaded nosler ammo do not use the same brass, different volumes, so maybe just thicker brass than the loaded ammo is supplied with. Measure neck wall thickness? Were your loads beginning loads and thus low pressure? Lack of expansion maybe but just enough to send the bullet and the brass just shrunk back? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
28 Nosler brass too tight after shooting
Top