Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
270 AI
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Guest" data-source="post: 108281"><p>Guess it depends on the chamber. I have only worked with one and when you loaded a factory round in it the bolt would close with a little resistance. When shot, the AI case was formed. If the chamber is to long for a factory round to fit tight than you must keep the case against the bolt head. There are a few ways to do this. Leave the bullet out of the case far enough to jam into the lands or use 30-06 brass and only sizs the neck far enough so you can just close the bolt. There are probably some other ways also.</p></blockquote><p></p>
[QUOTE="Guest, post: 108281"] Guess it depends on the chamber. I have only worked with one and when you loaded a factory round in it the bolt would close with a little resistance. When shot, the AI case was formed. If the chamber is to long for a factory round to fit tight than you must keep the case against the bolt head. There are a few ways to do this. Leave the bullet out of the case far enough to jam into the lands or use 30-06 brass and only sizs the neck far enough so you can just close the bolt. There are probably some other ways also. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
270 AI
Top