Bipods & Other Rests

Used for mounting 1913 rails (our part numbers BT15 and BT17) consists of two (2) 10-32 T-Nuts and two (2) 10-32 x ¾" Button Head Cap Screws.... More →

Bipod lock fits both Harris and Caldwell XLA bipods. This item enables you to get a good, stable lock down when you set up for that critical shot. On a sidehill you can adjust for the angle and ensure that your rifle will recoil the same way it did when you sighted in. This adjustment is also critical for correcting cant. Fits the Harris and Caldwell XLA bipods.

This is a great rear bag for the long range shooter. I used the LRH rear shooting bag last fall and I love it! It will lay on its side for a 2" lift, on edge for a 3.75" lift or on end for a 4.75" lift. The bag attaches to your belt or fits in your coat pocket, comes filled with polypropylene, and weighs only 12 ounces (avg).

The new BT15 3.35" 1913 Rail will accommodate hole patterns with a center to center spacing of 1.76 – 2.78" with a relieved base to accommodate... More →

This is the Atlas Bipod rail that you may want to use for a new installation if your front sling attachment consists of a flush cup on the side of the... More →

This is a slightly longer version of the rail attachment device. The new BT17 - 4" 1913 Rail will accommodate hole patterns with a center to center... More →

A great accessory for optics gear freaks to mount two optics to one range finder.

Works with or without quick release plates.

This Atlas Bipod leg extension kit gives you 3 more inches of height to result in my go-to over-all bipod height for most hunt trips. - Len Backus -... More →