Bipods & Other Rests

This is a great rear bag for the long range shooter. I used the LRH rear shooting bag last fall and I love it! It will lay on its side for a 2" lift, on edge for a 3.75" lift or on end for a 4.75" lift. The bag attaches to your belt or fits in your coat pocket, comes filled with polypropylene, and weighs only 12 ounces (avg).

Quickly change between a V-bracket and camera mounts. Available in both camo and black finish. Rubberized gun support for quiet operation and to protect your gun.

The Caldwell XLA Pivoting Bipods with notched legs provide a stable shooting support that conveniently attaches to almost any firearm with a sling swivel stud. The lightweight aluminum design adds minimal weight and deploys quickly, with legs that instantly spring out to the shooting position with the touch of a button.

Bipod lock fits both Harris and Caldwell XLA bipods. This item enables you to get a good, stable lock down when you set up for that critical shot. On a sidehill you can adjust for the angle and ensure that your rifle will recoil the same way it did when you sighted in. This adjustment is also critical for correcting cant. Fits the Harris and Caldwell XLA bipods.

A great accessory for optics gear freaks to mount two optics to one range finder.

Works with or without quick release plates.

I want the ability to quickly remove and re-attach my Atlas Bipod so I mounted this model on all my personal rifles.  -Len Backus- Mounts... More →

This Atlas Bipod model is meant to stay mounted on your rifle but can be removed almost as easily as a Harris. Two screw clamp included. Very slightly... More →

The new BT15 3.35" 1913 Rail will accommodate hole patterns with a center to center spacing of 1.76 – 2.78" with a relieved base to accommodate... More →

This Atlas Bipod leg extension kit gives you 3 more inches of height to result in my go-to over-all bipod height for most hunt trips. - Len Backus -... More →

This is the Atlas Bipod rail that you may want to use for a new installation if your front sling attachment consists of a flush cup on the side of the... More →

Used for mounting 1913 rails (our part numbers BT15 and BT17) consists of two (2) 10-32 T-Nuts and two (2) 10-32 x ¾" Button Head Cap Screws.... More →

This is a slightly longer version of the rail attachment device. The new BT17 - 4" 1913 Rail will accommodate hole patterns with a center to center... More →

The Atlas Bipod Pouch is designed to accomodate any of the  Atlas bipod models and includes compartments for leg extensions and either or both sets... More →