Cart is empty
Track my order(s)
Bipods & Other Rests
Read reviews (1)
The BT17 - 4" 1913 Rail will accommodate sling stud hole patterns with a center to center spacing of 2.2" – 3.5". It has a FLAT base to accommodate... More →
If your rifle stock only has a single sling stud and you don't want to add a 2nd anchor, then this is the rail for you
The Caldwell Steady Rest NXT Rifle Shooting Rests three-piece design can be used as a single rifle bench rest, adjusted to fit any length long gun by removing the middle connector, or use the front rest alone for handguns.
The Caldwell Pistolero is the ideal handgun shooting rest.
This is the Atlas Bipod rail that you may want to use for a new installation if your front sling attachment consists of a flush cup on the side of the... More →
This rail is similar to the BT34 but one end has a slot to allow for some flexibility in the distance between anchors. The BT49 – 2.05" 1913 Rail has a center to center spacings 1.2 - 1.6".
Read reviews (4)
If your rifle stock has 2 sling studs spaced from 1.76" to 2.78" apart then this BT15 3.35" 1913 Rail will work. It has a relieved base to accommodate curved surfaces, but can also be used on stocks with a flat surface if needed.
Bipod lock fits both Harris and Caldwell XLA bipods. This item enables you to get a good, stable lock down when you set up for that critical shot. On a sidehill you can adjust for the angle and ensure that your rifle will recoil the same way it did when you sighted in. This adjustment is also critical for correcting cant. Fits the Harris and Caldwell XLA bipods.
Used for mounting 1913 rails (our part numbers BT15 and BT17) consists of two (2) 10-32 T-Nuts and two (2) 10-32 x ¾" Button Head Cap Screws.... More →
© 2001-2014 Long Range Hunting, LLC. All rights reserved. Powered by Longrange Hunting