Brush/Mosey oak stock, New with mag well and spring short action
NEW
40.00 plus shipping
rob 6019487632
also have the trigger and scopes off the dicks package guns
J E Custom thanks for the tip,Rewording my search made a diff.I appreciate youalls input,I just started shooting about 1 year ago.Trying to learn all this and do it right.
Rob:D
This from Brownell's,
makes since if theres diff grades of the screws/fasteners.I would assume that most are...
Hey guys thanks for the replies,It looks like 28 is the most common torque value on the base screws.
I found on Seekins site he recomends 15 inch lbs
FAQ -
15 here also
Is a wheeler fat tool really needed for mounting scope? - TheFiringLine Forums
Ken Farrell recomemnds for his base...
Greyfox thanks for the reply,I hate to be wrong.I know the ring cap screws are a larger size that they say 25,Ijust cant see the same TQ on a smaller screw,
This chart is closer to the 25-30in
6 - 32 .00909 818 654 - 982 15 - 20
on a 6-32 says 15-20inchpds...
I just received a NightForce scope base/rail 1913picatinny for my New Rem 700.I'm trying to sight it in tomorrow.It didn't come with destructions:rolleyes: and Nightforce is closed ,the place were I bought it didn't know and guessed it to be 25-30inchpds,Everybody else is at the shotshow.I...
.
Im sorry Im all new to guns,so Im lacking on what its supose look/fit like.Ive got alittle idear though. Ive messed with race cars and race boats and stuff,Im use to having to make stuff fit.So how do I make all this line up and run?
If I put spacers to bring it flush in one area and cut...
Thanks for the reply
I seem to remember if I loosen one end/screw at a time the that end does come up,
But also when bolted up ,the metal magwell is hanging below the stock magwell area so much I thought this was not right,but was told it wasn't abnormal.So I pushed on the metal in that...
Another question, I shot it a few times last weekend single feed,when I took it apart the recoil lug on the barrel made a whiteness mark on the recoil pad of the stock.its only touching about 1/4 of the area of the recoil lug,just off center about .125 wide x .750 long. so its not flush with the...
I hope I gave anough info,The mag well is not touching the inside of the stock,it may be touching the center peice of the stock inbetween the triger and magwell.
With out the washer the front magwell looks like its touching the botom of the action,by the chanber.
Thanks again