Recent content by skuna boy

This was my first thoughts too...I double checked everything on the mounts and all good, unless something internal in the scope....but if it were mechanical.....would it not effect shots at both 100 and 300? Even at 300 it is consistent....just way low. I ordered a chronograph yesterday...

I have a 300 RUM with 26" barrel and since the powder shortage have ran out of retumbo so have been looking for something else to make due until I can find some. Since 50 BMG is so easy to get I figured why not and worked up a load doing a simple ladder 20 shot ladder test, starting in the low...

price drop one more time - $2500

barrel is 1 in 10 twist

price drop- $2750

more pics

round count .....is approximately 65 to 75. I have 65 fired pieces of once fired brass and the I know there a few pieces here and there that I'm not counting. The guy who put it together broke in the barrel for me with factory loads. weight.....11.6 pounds without bi-pod and 12.6 with...

300 rum 700 action and floor plate and trigger (pro-tuned and blue printed) Lilja barrel 26" #4 manners T2A stock night force titanium rings - high tally 20MOA base Leupold mark 4 6-20x50MM mill-dot custom brake build by local smith got over $4000 in it will take $3000 and I will cover...

i'll try and get some pics up this weekend. stock is black and the action and barrel is stainless

Manners Remington 700 MCS T4A (ADJUSTABLE / Vertical Grip / Hook / Beavertail) - black - never been bedded remington action - blue printed Lilja barrel - heavy sporter - 26" with custom brake and thread cap - broke in buy gun smith (approxmily 125 rounds through it) factory trigger - adjusted...

oh no way, a buddy was there to help and between me and him almost didnt get it on. by the way, who do you think took the pic of me and the hog? :)

didn't weigh it. figure 350 to 400. it was bad heavy.

.300 wsm 210 Berger.....15 steps

thanks, I will take it all into consideration. The first rifle is a 700 action into a manners stock. would you guys suggest attempting in a cheaper factory type stock first before jumping on the manners?

i plan on bedding a couple rifles i have and never went through the process before. Any suggestions on the best kit/product to get the job done? especially for someone new to the process?