Recent content by Rhunter2

I am looking at building my first rifle. I am trying to keep it reasonably light because it will be used in the mountains for elk. I bounced back and forth between the Anti and the Origin but the Anti is quite a bit lighter so I ended there. I am going carbon on the barrel to save some weight...

Fremont county, Robert welchans is the owner. You can see the ground on beacon.

I would have to find the listing agent but the was a good size piece just outside farragut on the river that would be an amazing place to hunt. If you look up the town it would be 1 mile north and 1 mile west. Mostly hunting with a few farmable acres.

My rifle was doing something very similar. It was almost like it was shooting decent groups but they were a few inches apart. It would randomly throw a bullet in one of the two groups. It was the action screws touching the pillars (thank you Montana rifle co). I drilled the pillar to enlarge...

I neck turned my brass for a 7 Rem mag. Used the k&m tools to do it. However, I stopped turning just short of the shoulder. I would guess I am 1/32” short. After researching this a little more, I think I may have screwed up. Apparently I should have turned just into the neck? I am really...

PM sent

I have a sbe2 that I would sell for $950. I haven’t shot it much but it has been hunted with. I upgraded the follower to a red anodized and upgraded the sight to a hiviz. It is a 26” barrel with the comfortech stock. The gun is black.

Anyone use these on their bipod? I bought a cyke pod and I believe the pass extensions will work. I would like to pick up the 17.5” for coyote hunting. Any drawbacks to that?

Rhett thank you for pointing that out. I am ordering the 2.0. I wanted the sling attachment.

Purchased a cyke pod and need to put pic rails on my guns. Ordered the seekins srs but they are flat on the bottom and I don’t think they will work properly. I have four guns to mount rails on one is a round free float ar tube and the others are bolt actions that are very round at the mounting...

I did not notice initially that the Hatch does not pan. I don't think that i want a bipod that does not allow that. When i coyote hunt, most of the time my rifle is hanging over a terrace and i have to move some to get on target. I think that would be very difficult to accomplish without the...

So how stable is that platform when the legs are set to a taller position and spread wide?

I did check out the javelin. Definitely like the weight. Really don’t want to have to screw on leg extensions.

I am very interested in this bipod. I don't shoot competitively, i just hunt. I know the Hatch is a bit heavy but it appears to cover everything from sitting to prone. I don't see another pod that does that without adding pieces. How stable is this bipod? I am a bit leary that they could...

I had the same issue on a Montana Rifle Company x2. The gun shot two different groups about an inch and a half apart. I took a rat tail file and enlarged the pillars so the bolts didn’t touch. Groups immediately dropped to well inside an inch.