Recent content by pjtruesd

Enter Me In The How to Dope the Wind - Beyond Belief Video Contest

If you want a SS SPS receiver I think you are going to have to go the "Buy the action and sell the rest of the rifle" path. The SS is more than the CM rifle, as I am sure you are aware. I too have been looking for a long time for a SS SPS in a WSM boltface on Gunbroker(saved search, email...

Enter Me In US Optics Rifle Scope Contest

Sometimes it is better to leave things alone. It may be throwing curveballs, but they are all going in the same place. Now just shoot it until it is a smoothbore. That should only take about 10K rounds. ;)

It is just as I suspected. Your problem is not in the holes for the scope bases, but rather in the timing of the barrel. Contrary to what most might think, rifle barrels are not straight. They all tend to have some runout in them, even the expensive ones. It just so happens that the bend...

You are also going to have to alter the feedrails. If you want to go to a WSM, I would start with an action designed for the WSM. You will be better off in the long run.

How do you know that the holes are drilled incorrectly? I ask because I can't see the rifle. You say that the rifle is very accurate and that you are able to mount a scope on it. I have a suspicion about what is going on, but am going to wait for more information.

"Enter Me In The Swarovski/Cameraland Contest"

Enter Me In The US Optics Spotting Scope Contest.

Enter Me In The Swarovski Z5 Rifle Scope Contest

I just ordered it today. They say it is limited to 50 lbs of recoil. According to their charts that would be a 375H&H 300 gr at 2700 fps. I figured there would be some fudge factor built in. 416 Wby? Ouch! You are a stud. Jim

Does anyone have experience with the above or knowledge of it? I would like to take the shakey human (me) out of the equation for load testing. Cabelas is selling them. Jim

Running the 220 is a piece of cake. I stressed over it for a long time, then found out how easy it was. First thing you need is enough room for the breaker, which takes two spaces. Then just run your wire from the breaker to just below the fuze box. You will only have to poke a small hole in...

Thanks for the info. That one piece bottom metal from Brownells is expensive. Jim

George, This puzzles me. You are a guy that builds super high speed Remington tactical rifles that shoot into the next county, and you bought a Winchester rifle off the shelf? Should this tell me something? If I didn't have a huge track hoe ripping up my driveway fixing the sewer line right...