Recent content by Pdog11

I am just hoping the H&R single shots come back.

My mossberg shoots around a inch at a hundred I didn't take a caliper to measure used a tap to measure so don't have exact. But I haven't had it to long and haven't done allot shooting with it. I shot a three round group. But I have a cheaper scope on it and haven't spent much time at a bench...

Not sure if you reload or not but with the mossberg patriot predator at least the one I have in the 6.5 prc factory loads just fit in the magazine. They cut a little V (might be more of a U) notch in them so they fit. So you can't load any longer then factory. I have the Ruger american predator...

bump for ya

they use to make a low wall single shot did they drop it. Was more then I wanted to spend but did look at one online once.

Its a curios and relics ffl. For guns that are older then 50 years or are collectable.

Do you ship to a C&R?

Nice have the revolver been thinking about a encore barrel but never pulled the trigger kept reading about frame stretching but maybe that was just the 500.

Won't change my plans to hunt. But I only hunt 15-20 mins from my house. Hopefully the tresspassing out of area hunters on the property next to ours get scared though.

Not sure if anyone is looking was instock when i was looking

Not much help but Mossberg Patriot is sold in 6.5 prc to.

If you just want brass all I have that's not listed is tcm9r but think its the same as the 22 tcm for size of brass, 224 valkyrie, 338 federal and 17 wsm. looked again didn't see a 6.5prc so threw in that brass.

I do shoulder shots since I hunt 55 acres with the land around it, that is leased to a hunting operation. Have had problems with the pay hunters tresspassing on the spot I hunt. Found two of their blinds this year on the land we hunt. I only hunt deer.

Its a they hybrid 46. guess i should have added the 46. Its the silencer co one. Plan to direct thread it if it worked. Thanks for the replies will look into more stuff.

I want to suppress it with the hybrid I am getting hopefully next fall. Was just worried it was going to be to thin. The guy I talked to said he could thread it but wanted other opinions. Its 0.6135 inches at the muzzle with my cheap caliper I had handy. Don't really want to shorten it to much...