Recent content by Palix-Dog

Cow elk at 15 yds. Muzzy 100gn broadhead.

Wyoming Antelope 512 yds 270 WSM, 240gn Accubond.

Nosler 175 gn Accubond Longrange with 66.2 gns of RL22 for 2970 fps.

I found my rifle likes them seated at 6 thousands off the lands. Shooting 0.4 moa. Not bad for a budget hunting rifle with hunting bullets.

If you go to ammoseek.com and search under the reloading tab at the bottom of the page there are several vendors that currently have them.

So far I've tried Magpro, Staball HD, H4831sc, and RL22. They all give good accuracy but RL22 is the only one getting 2970 ave fps. But it's virtually non existant. The rest are only getting around 2800. Maybe I will try N565 or N570. I hear Retumbo is giving good results also.

Thanks for the update. I have some 175 ABLRs. I have been working up a load for my 7mm PRC using a combination of Hodgdon and Hornady load data. I was just wondering about the Nosler data. I am getting less than 1 moa with several powders but not excited about the velocities. Seems like my...

So when is Nosler going to publish load data for the 7mm PRC? I am only seeing it for their 185 gn bullet and with only 3 powders. Any insights?

59 gns of RL19, Nosler brass, 160gn Accubond with winchester LR primer gives me 2915 fps with no signs of pressure. My last elk didn't like that load. DRT at 200yds.

Same here. Only Alliant I have seen available is RL16. I still have some RL 17, 19, and 22 put away. But when it is gone I need a back up. I use these in my 270wsm. 280ai. and 300wsm.

I'd like to try some n560. I also have Magpro. I may try a few loads with it and see what I get.

I also ran out of Fed 210s. I tried CCI 250s because I had them. They gave me a huge ES. I found some Win LRs and they seem to work fine.

Yes Kimber Hunter 24" barrel. RL19 gives me 2915 fps and RL 17 is 2950. Both around 3/4" group.

Mine likes 59gn of RL19 also 2915 fps. 56gn of RL 17 is its favorite load but I don't have much of that on hand and seems like the quit making it. Luckily I still have a couple of pounds of 19 left.

How are the primer pockets holding up on the Hornady brass? I've been working up a load and after the 3rd firing have lost 5 out of 20 cases to loose primer pockets. None of the loads are over book max.