Recent content by Nhyrum

I get that, im not looking for shortcuts. Just a curiousity that popped into my head, if formed edge brass would have the same capacity of factory edge brass. id be starting with ADG most likely and comparing it with ADG factory

I know that its a necked up 300 rum. what im wondering is if the case capacity of a factory 338 edge and a necked up 300 will be the same. looks like ill probably buy ADG

thats what im seeing. bertram is terrible in terms of weight consistency and neck thickness, and rim thickness. im curious what your SD was for weights. while yes, you want the deviation as close to 0 as possible, percentage wise 11 grains has the potential to be a very small percentage. but...

so, ive done a little digging, and have found the consensus is that adg is "better made" for lack of a better word, but pressures out sooner(stiff bolt lift, extractor marks, etc,) than bertram, and bertrams primer pockets hold up more. I heard this was a early run issue with ADG. the posts ive...