Recent content by kostianych

that how I was thinking about the problem..... but the dealer advised me that this is the way to have the neck survive longer, in his words: "...this conical part will become thiner with time and it will give you more life-time for brass...: what a.......just convinced him and sent it back...

seems like I was right about 1/2 neck sizing :) thanks for supporting my thoughts :)))

thanks guys, just sent it back to the dealer....for refund :( now I need a new tool :)

thanks a lot, woods :) seems like my Forster has a problem..... when I move the cutter to the pilot, it touches it only in one point, opposite to the shoulder angle.... in this case I have not a cylindrical but conical neck..... if you look at the light though the tool, does it have an angular...

hi guys.....could somebody take and post a close picture of the Forester neck turning tool when the cutter is slightly touching the pilot..... I think I have a problem with missallaignmnet..... thanks a lot

:D I`m from Wild Rose Country :) Alberta :) Prairies and Mountains, Oil and gas Country :)))

hi guys! glad joining your great site :) I look forward to learning a lot more from all of you!gun)

hello, I have a question for you, if you don`t mind I just got the Forster neck turning tool and hove to ask you: the cutter edge is not parallel to the pilot.... when I move the cutter and touch the pilot, one side (opposit to the shoulder) is touching the pilot, but the other one (closest to...