Anyone have a pet N570 load with Berger 180’s? I’m toying with 8727 also but so far only have very accurate RL26 load data for my 26” 8,5 twist 7Max and I’ve been unable to source RL26 in the last couple months.
The bottom of your turret housing should have a flat spot. If you also have a flat surface on the top of your action below the turrets, you can slide a narrow steel ruler between the bottom of the turret housing and top of the action and rotate it until it touches both. If it isn’t flat across...
It’ll be on MY shelf tomorrow then. I’ve only found oddball stuff here in Houston in the past few months. I run 7828 in my 300 wby and 300 wsm and both drive tacks - I assume that’s not a powder the Max would play well with? Everything else I stocked up on powder for is either 4350 (H & IMR...
Mine seems to like 63.6 gr for grouping with formed brass. That puts it right at 2,980fps and 0.3 MOA. I’ve only been able to find N570 now so back to the drawing board for new load data for a while. The barrel is Bartlein #3, 26” 1:8.5
Fireforming recipe for new Sherman 7 Max (ADG) brass (and a heck of a group). This is what the awesome folks at WTO used to prep the brass for my new baby. Good luck finding RL26 though.
My first official post - hopefully I don’t screw it up. I received my 7Max from Clayton out at West Tx Ordinance, who has been a pleasure to work with, and this baby is absolutely beautiful in person. I’ve had N570 on backorder for a couple months and it finally shipped out from Midsouth today...