I just called and ordered two special TI pro 4 self timing muzzle brakes from Salmon River solutions. as you check out, there is an area for notes. In the notes section, you just put what caliber gun you plan to shoot it on and they will drill it out accordingly.
Yes, I have had many problems with TPS. I didn’t even know they were still making products because several of the sites that I ordered them from stopped carrying them and I never could get through to customer service. It’s too bad they make a really good decent set of rings.
I do have two 6.8 SPC‘s with about 1000 rounds of factory Hornady ammo. I use it to shoot deer, hogs and coyotes so this is just a neck down version of the 6.8. I really don’t see why it wouldn’t be a good alternative to the Creedmoor or 22 ARC.
But if they screwed up the barrel, twist rate...
After playing around with this one thing that I observed is to use the hard stop buttons at the bottom when you are doing decapping or seating procedures. But when you are resizing the die, it’s best to use the camover buttons.
Your Brass will need 2 to 3 firings to be fully formed to your chamber. What is your neck and inner diameter dimensions for your neck to bullet interference fit? Recommend using powdered graphite, size with a mandrel prior to seating a bullet. Is your brass neck wall thickness uniformed? What do...