Recent content by jrg

  1. J

    Scope clamp screw torque on ARC M-brace rings with a Sightron SVIII 5-40x56.

    We Run ARC RINGS on our 6 BRs & have for about 5 years now on Nightforce scopes. we have always torqued at 55 inch Lbs. with no problem at all. Of Course, there is very little recoil with the 6BR, but I would recommend these rings for any combination. Also, there are no ring marks on your scope!
  2. J

    Recommendation On DBM - Defiance Deviant

    Yeah, I didn't catch the last part for a BDL! My Bad! We use ours on a bench rest gun with a foundation stock.
  3. J

    Recommendation On DBM - Defiance Deviant

    We use KMW MK1 dbm & PMags with our Defiance deviant, works like a charm.
  4. J

    SS pins - a note of caution

    We stopped using pins because they would get hung up inside the brass & ding the necks, Started using Brass Juice & it works just as well without the hassle.
  5. J

    Proven load now resulting in clickers?

    I had the sa I had the same problem after 3 firings, Clickers, I changed sizing Dies & problem solved!
  6. J

    Modified Magnetospeed

    It only changes POI ever so slightly on my gun, However, In my opinion, they should not be used when shooting groups but only to collect data.
  7. J

    Help Fine Tuning 6BR

    My Sons barrel is a little faster than mine 2800-2820, But mine is 2780-2800
  8. J

    Help Fine Tuning 6BR

    We are running basically the same set-up as you, Defiance Elite Action & Bartlein 5R MTU, 26", 1:7.5, chambered by Wade Studeville. I shoot 107gr. SMK's with 30gr. Varget & CCI 450 primers in my gun at .014 off the lands. .250-.300 groups at 200 yds. My Son has the same set-up except he uses a...
  9. J

    Testing Cases After Resizing?

    Sounds like your sizing die is either not set up correctly for a .002 shoulder bump or the die is not sizing your brass enough just above the case head. I was using a sizing die that would not resize enough .200 above the case head that was making my brass hard to chamber, switched back to my...
  10. J

    V3 Magneto Speed POI Change?

    I shoot a 6BR & the change is minimal, however, I only use it for numbers, not groups.
  11. J

    Accuracy Loss

    If you removed the carbon & copper from your barrel when cleaning, you may just need to refoul your barrel. I would shoot 10 or so foulers & then see where you are!
  12. J

    Reducing ES

    What kind of powder scale are you using? What do your groups look like with that high ES? A good set of scales can reduce flyers & ES along with good brass & good brass prep. I don't believe neck tension will cause those high ES numbers. Once you get your ES down considerably then you can...
  13. J

    Improving ES in 300 WM is it just powder selection

    Powder, Neck tension & Primers!
  14. J

    New Brass Problem

    I use Lapua Brass, but I always go through the same process with new brass as I do with fired brass which includes resizing
  15. J

    Need a ring recommendation

    I have been using the ARC M-10 rings for several years now & have never had a problem or any ring marks! I would highly recommend these to anyone!
See more

Top