My load for 6.5 Creedmoor using 124 Hammer Hunter:
Lapua brass
39.8 grains of Varget
CCI 450 small primers
Avg velocity 2,967
SD 2
ES 7
Excellent grouping under 1/2 inch
Living in NC you may want to contact Dan Glover of Dan's Custom Gun Service. He lives between Wake Forest and Wendell. Phone number 919-604-1651. Has built a couple of rifles for Donald Trump, Jr. He does very nice work.
Call Dan Glover of Dan's Custom Guns. His number is 919-604-1651. He lives just north of Raleigh, NC and has built numerous custom rifles for members here including Donald Trump, Jr.
Give Dan Glover (Dan's Custom Guns) a call at 919-604-1651. He is near Raleigh, NC and has built several guns for folks here including DonTrump, Jr.. He also advertises on this site. He also is a sponsor of this site.
I was in Montana last week hunting and decided to give the guys at Hammer Bullets a call to see if I could stop by. Steve was on the range working on a clients load for a 7wsm but said he would meet me at the shop. He gave me a great tour and showed me in detail how his cnc lathe worked. He...
I agree about the carbon ring. I had this problem and my initial indication was difficulty trying to determine CBTO for a new bullet. It took a lot of scrubbing by my gunsmith and then by me to correct the situation.
I just fired my first 124 Hammer bullets from my Christensen 6.5 CM and was very pleased with their performance. Using Varget, I'm getting 2,950 fps with 7 SD and
17 ES. My first three shots measured just under .25. Standard factory barrel 1:8 twist.