Howdy
looking for a Savage LA acufit RH with aluminum block. The one you can modify LOP and comb height. Sporter barrel channel preferred. But would take anything for the right price.
thanks for looking
Traditionally I’d check Hodgdon’s website as a second reference or ideas on what powders work for what
BUT
it’s all messed up. It just sends you to the different powders they sell
No option for caliber, bullet weight, powder
Any ideas?
I have a small aluminum jig that goes on a little harbor freight chop saw that holds a 5.56 case in order to cut it down to 300 BO length
THEN you lube and size
https://www.squirreldaddy.com/Deluxe-300-Blackout-Case-Trimming-Jig-p/sd24-102.htm
it’s yours if you want it
You pay for shipping...
Haven’t found one anywhere in about 10 mo. Looking for a Ruger Blackhawk convertible 45Lc/45acp 4 5/8th barrel
prefer new model not 3 screw
Not flat top frame
thanks for your time
I would not do that
You could try a dummy 1st if you are worried.
look for “land marks” on the bullet
Trust your measurements
If you can’t trust your measurements, go back to the book values.
Sounds like that the Nosler book recommendation is 0.179” from your lands
IN YOUR RIFLE
that’s pretty far
Some Nosler bullets like to start 0.02” off lands.
So initial COAL is 2.989 - .02 = 2.969 COAL
Yes longer than Nosler recommends
all rifles are different
remember,It might not fit in...
Are you saying the gauge showed you your lands touch the bullet at 2.989 COAL?
Is your 2.810 measurement from factory ammo? Or Noslers book recommendation?
This may be based on industry standards
If your lands touch bullet at 2.989, now subtract from that how far you wanna start off lands. Use...