Recent content by Jed Cooper

Straight walled pistol cases mainly. Usable for 22 hornet and 300 Blk-out

I shot both today and my BLR defiantly liked the PMC 308 as opposed to the Win 7.62 M80. The 7.62 had bubbled looking primers(slightly domed shape) as if a headspace issue and printed 3" higher at 50 yards than the 308. Extraction was normal with both loads. The 308 PMC primers looked very normal.

Thanks. I did get the rings today and wow, those are some big-arse rings. They're wider than the BLR's receiver. No doubt they're super strong.

I have a BLR I'd like to mount a compact scope like the Leupold VX-6HD. Are there any other scope makers that offer the quality but at any cost savings? I did settle on the 30mm Seekins machined picatinny rings.

If in the wrong forum I apologize. Should I have any problems shooting and/or extraction with factory 7.62x51 Nato ammo in my 308 BLR, or Ruger bolt 308? Thanks in advance.

I had the same problem and ended up installing a Magpul stock.

When did CCI first start using the dark blue box with the silver "swoosh"? I've got some of these blue box primers with the lot# of K15B302, but based on the old lot ID scheme these were made in 1996. The best I remember in the mid 90's the boxes were the old white and red variety. I believe...

H4350 still there

lol. Sure did

A heads up. FYI

Deleted

I didn't know folks still used case lubes and pads, I ditched mine when Hornady's One Shot came out.

I have a FX120i too, while I don't really need the great resolution, I like the no drift and instant display which speeds production. Also I'm a big fan of quality equipment in any of my hobbies.

I'm on the fence about this one. Overpressure and excessive pin protrusion??