Recent content by GlennRMK

Check it out here H-S Precision Remington 700 SA Black /Gray web stock HS - eBay (item 320599065228 end time Oct-10-10 17:14:42 PDT) Its in like new shape. Black with grey webbing. Remington 700 Short Action

Enter Me In The Swarovski Z5 Rifle Scope Contest

Enter Me In The Swarovski Z5 Rifle Scope Contest

I have a Browning A-Bolt Varmint Stalker in 22-250 Seems to shoot very well. My best three shot group is .1"(basically one egged out hoe) with 32.5 gr of IMR 4064 and a 50 gr Ballistic tip at about 3600 fps. This is with the bullet about .035" off the lands. Best 5 shot group is around...

I've loaded 2 different 300 Win Mags, both Tikka T3s Both seemed to like Hornady SST 180 grain bullets I tried various powder in both. RL22, IMR7828, H4350, AA4350, IMR 4350, Hybrid 100V, and H4831SC. One gun only seemed to like AA4350 The other liked H4350 and Hybrid 100V Just a...

Thanks for the suggestions guys. I finally had some good luck with the TTSX and RL17 today. Wind was calm and temp was around 55 deg F. My rifle: Remington 700 CDL SF .300 WSM with HS stock and sako extractor. I weighed the bullets and all 3 were within .1 grains. Did not weigh...

I had some good luck with it today. Wind was calm and temp was around 55 deg F. Tried 168gr Barnes Tipped TSX in my Remington 700 CDL SF .300 WSM with HS stock and sako extractor. . I weighed the bullets and all 3 were within .1 grains. Did not weigh cases. I used brand new Winchester...

How far off the lands are you? In my gun that would be in the lands.

I haven't gotten the best accuracy with it but have seen increased velocities. Hitting over 3100 fps with a 180 grain bullet in my 300 WSM without exceeding the max load listed on Alliants website. I am yet to try it with 165/168 bullets but I plan to try it.

Definitely look into what bullet you want to run. For instance can be over .100" difference in seating depth between bullets. In my Remington 300 WSM the 180 SST hits the lands at 2.865" while the 200 Accubond hits the lands at 2.980" if I remember right.

I'd be interested in results. I haven't experimented with length a lot.

Shooting a Remington 700 CDL Stainless Fluted in .300 WSM. Have tried the following bullets: 200 Gameking 200 Accubond 180 SST 180 Interbond 180 Accubond 180 Scirrocco 180 Gameking 165 Accubond 165 SST 165 Interbond So far the 180 SST shoots the best. Followed by the 165 Accubond and 180...

I've handloaded for a couple of my buddies. Both had Tikka T3s in .300 Win Mag. Both had very long throats. Most of my loads would only allow the bullets to be within .150 to .200" or more due to magazine clearence. Both rifles were capable of sub .5" groups at 100 yards. I usually put...

There's an article about the e tip and the 270 wsm in this month's issue of Shooting Times I believe. Has a green stocked FN rifle on the cover I think. I think the best load(accuracy wise) they had listed was IMR7828SSC @ 3200 fps

Know someone that had a Kimber and he like H4350 and the 200 gr Accubond. I'm unsure of the charge or primer but he said .015" off the lands.