Recent content by Footsore

  1. F

    230 Bergers and 300 RUM

    OAL is 13thou off lands and doesn't fit in mag. Very similar to Smoked's load. Same primer just I am running 90gr Retumbo. Quite mild in my rifle because of the bullet seated right out but with the factory barrel accuracy goes away if loaded any hotter. As usual start lower and work up.
  2. F

    230 Bergers and 300 RUM

    I have a load using the 230 gr Berger and Retumbo that gives me 2910 fps and good accuracy from my Remington SPS stainless with factory 26" barrel. Quite happy.
  3. F

    300 RUM & 230gr Berger Hybrids

    My load in a Rem 700 factory rifle is 90Gr Retumbo 230Gr Berger Hybrid Target lit with a Fed 215 primer. 2911 pfs with no pressure signs. Accuracy is good at this load. If I increase the charge the accuracy decreases.
  4. F

    300 rum

    I reckon lighter bullets going faster will do your barrel in faster. Stick with what you are using and use it for hunting it will last you a long time. Get yourself another rifle like a 308 for range use.
  5. F

    300 rum

    Any increase in powder weight and the groups just open up. Give your rifle a good chance to cool between shots and you might find it will do better. The third shot in a string will have that SPS barrel really heated up.
  6. F

    seating depth 208 amax 300rum

    Were you using the exact same projectile that you used the first time you measured it? With those long bullets it can be very difficult to get a consistent reading even with a comparitor. Also with them even a very small amount of erosion of the throat can mean the bullet can go much further...
  7. F

    300 rum

    I have the same rifle as you and have two loads for it. For magazine use 200gr Accubond on 92gr Retumbo lit up with Fed 215 at 3.660" For long renge single feed 230gr Berger Hybrid Target on 90gr Retumbo with Fed 215 OAL 15 thou off lands (Very long). Both loads give fine accuracy well under 1"...
  8. F

    Ejector mark on 3oo RUM need advice

    Did you have any oil in the barrel for that first shot? That can really boost the pressure in a 300 RUM. Make sure that you clean all oil out before firing.
  9. F

    OAL

    I am loading the 200gr Accubonds at 3.660 for magazine length and the 230gr bergers way longer. The Bergers are 10 thou off and are definitely just single loaded.
  10. F

    230 bergers

    Thanks Durak, I was just wanting to see what others are getting. I am getting just over 2800 with Retumbo in my factory 26" barrel with quite good accuracy. 3000 is possible but I don't want to push too hard. A longer COAL nearer the lands with the factory freebore seems to allow a lot of...
  11. F

    230 bergers

    Hi Durak, What barrel length are you using to get that velocity? Very nice shooting!
  12. F

    30 cal 215 gr berger hybrid

    Looks good! Have you chrono'd these loads.
  13. F

    300 RUM or 338 Edge??

    I have also just started loading the Berger 230gr hybrid target in a 26" barrel but my velocities are a fair way below what Woodchopper and Bob are getting. Using Retumbo I have chrono figures of: 89 gr 2800 ave with 61fps ES, 90gr 2826 ave with 16fps ES, 91gr 2886 ave with 12fps ES. These show...
  14. F

    Seating Depth Berger 230 Hybrid OTM

    I am watching this post with interest. I am loading for a 300 RUM with the Berger 230 gr Hybrid target bullets and am wondering how others handle the calibers long freebore. I am seating .030" of the lands for my first loads with a COAL of 3.914. A max load of Retumbo as recommended by Berger is...
  15. F

    30 cal 215 gr. HYB

    Hi Korhil What was your accuracy like with that bullet at the 3040fps?
Top