Recent content by FastDam

Winchester Model 70, .300 R.U.M.. from winchester custom shop I believe. Dies and some brass, ???

Lol......."2900 yards for elk"? No 30 cal bullet has enough energy at 2900the yards to effectively hunt elk. That's reduliculous. I have shot many elk with many different weapons and I can tell you now that is a bunch of bull hockey. Now go ahead and argue...............

The Rewilding Project | Mission of the Wildlands Project

Tieton

If your bear doesn't either drop at the shot, or give a good blood trail, the bear may be very hard to find and dangerous to look for. A400 pound fat fall bear is hard to get a blood trail from even with a large bullet. IMO, 243 is way undergunned for everything except maybe yearlings. I lost...

If you have to question which one to build, then build the RUM first to be sure you are covered. With the higher section density you will have an advantage over the 7mag on bear. You need an exit wound for tracking

Make sure to have a 44gun on your hip when you go into the thicket to track your bear through his tunnels in the brush. He will attack you if you corner him after you shot him, and he will go straight into the thickest cover he around. Any neck shot other than just grazing it will destroy the...

You wont get an exit wound or a blood trail. Your bear will run off and dijie in the thicket

I have shot bears with bullets and arrows and they have all been very tough animals. I"m sure your 100 grain bullet will kill the bear, but will you be able to find him when he dies? My policy is to get exit wounds on bears so your chances of a good blood trail are better. If I was hunting...

BANG!!!..........bye bye

We don't have to tolerate wolves in our woods. Just use discretion. Screw WDFW they are following direction from foreign governments and shutting us out of our woods and wild places. United Nations directives control the WDFW agenda. U.N.. Agenda 21. is the document writer by the United Nations...

I have a wWinchester model 70 chambered in. 300 Remington Ultra Magnum. I just started to handload and I have started working up a bowler load for 200a grain accubonds straight out of their book. I don't know my barrel twist rate and I don't know where to find it. Does anyone else know more...