I had a shilin barrel on a rifle years ago. Long story short the accuracy went to crap and I spend about 5 years on and off trying to figure it out. Finally someone told me Shilen had some bad steel at one time so I contacted them and told them the story, time line and everything. Their anwser...
If you are wanting a hunting rifle just have it drilled and tapped for a scope,bend the bolt, have a new barrel put on and get a new stock if you want. Bedding the stock is a good optin but that should be a great 30-06. It might keep sub MOA some of the mausers were built to very close...
Bend the bolt
Square the lugs
Square the bolt face.
Square the action where the barrel screws into the action
Square the threads in the action
Trigger replace or trigger job.
Polish the raceway
A custom action already has that done. All that helps accuracy. A CZ would need many of those done...
I have been down this road a couple of times. Long story short the Mauser 98 action is a great action, but by the time you spend the money on bending the bolt, buying the rifle, blue printing etc you could just about buy a custom action ready for a barrel. If you want a 98 action buy a...
About 250 yards on a running coyote with a Savage 110 in 22 hornet with open sites in Northwest Oklahoma when I was 16. I wish I could say it was all skill but it was mostly luck.
I prefer to use my stalking skills and get a head shot if possible.
All rifles are diffrent and to many variables like bullet, powder, length of barrel.
Long story short when a bullet goes subsonic it destablizes and pitches and yaws more and it hurts the accuracy. How much again depends on many many factors.
The law is NOT about the enviroment, but a back door to stop hunting and firearms ownership in general. I moved out a few years ago. Will not be going back.
I know it is not sexy or exotic but what about a 30-06 with a long barrel. You should get long life from the barrel and it will go out a long ways. Not sure it will make it a full mile out but then again you may have to go to someting like a 338 Laupia or a 6.5-284 for that. I have an 06 I had...
Anyone know what parts if any will fit with a little modification? Specifically the stocks and magazines? I know it will not be a drop in fit but can they be modified to fit? Any other parts interchangeable?