Recent content by Daves22-250

Enter Me In The Berger Bullets Contest

Enter Me In The Lapua Brass Contest

As shown in the picture above, the only part sized is approximately the top .210" of the neck and the shoulder. The rest of the brass is not sized at all. The round chambers fine. If I understand this thread, I don't think there is a reason for donut to build.

Here are some pictures of my reloading bench I built in my RV. I have a 41 foot Heartland Cyclone toy hauler and it has a 12X8 foot garage in the rear. I used a 2"X6"X5' board for the bench. I made it this small so that I can park my car in the garage during travel to my destinations. The...

This is my first post. I read this thread with much interest. I have a few questions to ask and I'd like your opinion as well. I'm about to start neck turning my 22-250 Rem. brass and I've never done this before. I've been using the Foster Bushing Bump Neck Sizing Die with the .251 Neck...