Recent content by czymtn

Too much LemiShine - it's fairly acidic, so reduce that. Don't tumble excessively long w/pins (esp. w/the LemiShine) - beats the brass up a bit. You can get tarnish and water-spotting by not drying also, depending on water source/quality. Rinse the brass in clean water, post-tumble, and drain...

Hi, this will be repeating some of the others, but depending on your route, here are some good options: Billings, MT - Cabela's (just N of I-90) and Scheel's. Don't miss the 'gun vaults'/separate rooms - that's where the nice stuff is. Cody, WY - Buffalo Bill Museum - awesome gun museum...

Hi, Just had an issue w/that. I'd double-check, but if a new model, you should be OK. I had an original Bonanza CoAx - great press and still working like a champ. However, I discovered that for the mega-mags (RUM's, etc.) with match (micrometer) Redding Comp dies, the yoke wouldn't clear the top...

First press was an RCBS Jr in the late '60's - it served me well for a number of years. Then, I got an original Bonanza CoAx (same basic design as the Forster, who acquired it) - excellent press and I just sold it (in perfect working order) and replaced it with a B4 Forster CoAx for the...

Hi, Is this the original, 'full-size' GRS, or the newer, lighter 'Decima' model? thanks!

PM sent.

Hi, Are these FFP or SFP's ? Thanks.

"Enter Me In The Flatline Ops Contest"

Re: Custom 338 Lapua What's that 'biathlon-style' sling you have on that rig? Looks nice for carry! Thanks.

Hi, Are you (or anyone else) still looking for an XP-100 top rib/sights? I finally got them dug out, and I have an OEM rib with front/rear sights, screws, etc. - all the parts - from a '70's vintage XP-100. This would be for the original 10.5" barrel model. All parts are Remington OEM and...