Recent content by coach p

2012 within about three months from each other I turned down two Barrett M107's in Barrett cases with Ammo and Bi-pod's. One had a Leopold scope and the other had a NF. One for 1500 and the other 1000. Couldn't do it because I lived in the wrong State and I didn't want to loose my FFL. Then...

If your looking to go with a new Bow there are a lot of nice Bows with smooth draw cycles out there. Mathews, Bowtech, Darton, Elite, Hoyt to name a few. I suggest going to a couple of dealers in your area and try them out. Lower poundage 55 to 60 with an 85% let off is awesome and will...

If I only had $700.....probably a Labradar. That would leave about $50 +/- to buy targets.

If things ever got to the point where your on your own and defending yourself I would break my selection into two categories. In or on a vehicle and on foot/bicycle. In or on a Vehicle: Compound Bow for stealth 300WM for long engagements .22 rifle for small game 9mm handgun 5.56 AR for...

Ok need a little advice on finding a good replacement stock for my Kimber. I have a Kimber Hunter 84m in 6.5CM and cant wait to remove the cheap stock it came with. So I am looking for suggestions that are not wood and wont break the bank. Any help would be awesome. Thanks, Coach P

My first bow was a Darton SL-50 with a draw weight of 70#. Second bow was a Hoyt Maxis-31 with a draw of 65#. I won the third bow at a RMEF banquet. Its a Mathews Triax with a draw of 65#. I love the Hoyt and the Mathews as they are super accurate and quite with there setups. But I will say...

I saved my pennies and only use Lapua brass in my hunting rifles, (not a brass snob). I have tried other brass and found that the Lapua brass is more consistent than other brands in powder capacity and wall thickness. Anyway after my case prep is done I anneal the cases, however I anneal on the...

If you put it in a soft case as suggested and then into the hard case be mindful of the hinges as over stressing them will damage it. What brand hard case did you get? Here are some options to help you with making a decision. A. Don't cut the foam B. Cut the foam and dedicate it to that...

Afternoon Gents I find myself having to relocate for work and need advice on how best to store my rifles/Handguns. They might be in storage for up to three years and I don't want them to get damaged. So what should I use to protect the barrels, actions and wood stocks?

Still available ?

I have had the same experience with the different brass manufacturers. Brand selection does matter IMHO, as they are all different with capacity's and performance. I use Lapua exclusively for all my tools. Doesn't matter between hunting rig, tactile rig or competition rig they all have the same...

Gents, I have a Savage 110BA in .338LM and have just shot the last of my very expensive Remington factory loads. I am looking for some advice on where to start my hand loads. First let me tell you where I am thinking of starting and then you guys can give me your thoughts. Case: Lapua...