Recent content by BCJ

Yes, 915 yards and she didn’t take one step. Jacket was under the skin on the opposite side.

If you do not resize the entire neck you will eventually form a donut inside the case of the neck. Would recommend changing to a bushing die that allows you to resize the entire neck or change to a standard die that allows you to resize the full length of the neck then order a mandrel to open...

Lathrop and Sons, custom boots and insoles…they specialize in what you are looking for.

You have the wrong one. Try using the Hatch Outwest bipod you can shoot from sitting or kneeling or prone. Also have you looked at tripods

Hat Creek training if you can get in, Bryan Morgan’s place is amazing and you are shooting in some big country out in Idaho

The problem is your chambering. The rear part of the chamber cut is .002 too small. Go check out long range only they have a good article on it regarding cases sticking. Also order a JGS AW2 reamer and it will fix the problem. I had some Hand loaded 135 ATips with all kinds of pressure issues...

Your base line is not correct then on the Hornady App. Check all of your inputs regarding your gun, establish your Zero Angle and Axial Form Factor. Bad input creates bad output.

The 10mm will do the job and I highly recommend buying a Glock or similar package. You need to have a light on the gun due to walking out and in while it is still dark. It is critical that you have a gun that you can shoot quickly and accurately and the Glock will fit this bill.

I would recommend lapping your scope in If all the above Advice fails to eliminate the flyer. Or lapping your scope in can create stress on the scope and this will reflect down range