Precision with Factory Match Ammunition

bill123

Well-Known Member
Joined
Jun 14, 2013
Messages
743
I'm shooting .308 168gr Federal & Black Hills Match ammo. My 100yd groups average 9/16", with shots between 3/8" & 3/4". Occasionally I squeak out a 1/4" or smaller group. Occasionally I shoot a 7/8" group. I'm shooting prone off a sandbag w/a rear squeeze bag.

My rifle is a GA Precision. My scope is a Schmidt Bender. For argument sake, lets assume that the scope is installed properly.

Is that about all that I should expect from factory ammo or do I need to work on the fundamentals?
 
If it was a full blown Ft-r custom rifle weighing 22 pounds with a bat action you might expect a little less. sounds like great accuracy to me.
 
Warning! This thread is more than 11 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top