elkaholic
Well-Known Member
Has anyone had any experience with this brass? I have not had the best of luck in the past with other Hornady brass so am curious as to how I'm going to fair with my 30/375 S.I. Thanks........Rich
Hornady 375 ruger brass
- Thread starter elkaholic
- Start date
Help Support Long Range Hunting Forum
Short of the weird bolt face why not build it on the 6.5x68 or 8x68 and use RWS brass? It's a little more (1.70 each) but it's also higher quality. Brass forming would be easy with a neck down and fireform. The .257 Banshee was made on this case and got every bit of the capacity of a STW if not more.
elktaxi1
Well-Known Member
i'm up to 5 times on my 7mm 375 stuff
elkaholic
Well-Known Member
Too late, but thanks for your response.......rich
elkaholic
Well-Known Member
Is yours the LRM?.......Rich
elktaxi1
Well-Known Member
no mine was built in 08 before the lrm its close but i have a 45 degree shoulder and my walls are straight. i also had a 338 campfire(338-375) and i got like 6 times on them.
elkaholic
Well-Known Member
Yours sounds an awful lot like mine. Mine has a blown out sidewall and a 40 degree shoulder.. What is your capacity?.........Rich
elktaxi1
Well-Known Member
rich i have been shooting something like 74 of h1000 with a 160 accu bond. i'm working on a load with superformance to see if it will work. it works wonders in my 375 with a 260ab. and water cap is about 95 grs if i remember right that might be at the bottom of the neck
elkaholic
Well-Known Member
Thanks, mine is 95 grs. full to the top so I would guess yours is probably the same. Have you tried Retumbo?.......Rich
elktaxi1
Well-Known Member
no not yet but i want some of the new rl33
elkaholic
Well-Known Member
Hadn't heard of that one? Must be Sloooooow!....Rich
