270 WSM with 110gr Accubond

[squirrelduster]

I am planning on loading the 110gr Accubond but there is no load data on where to start.
It is for my Dad's rifle and he plans on maybe a coyote or two and our small blacktail deer.
Anyone with a load program that could run the numbers for me?
Thanks

 

[Popapi]

I am planning on loading the 110gr Accubond but there is no load data on where to start.
It is for my Dad's rifle and he plans on maybe a coyote or two and our small blacktail deer.
Anyone with a load program that could run the numbers for me?
Thanks

Anyone do this load!??????

 

[cstilt]

I've no experience with that load so I can't tell you exactly. I do have a Hornady manual (7th ed) that lists loads for the 110gr Vmax and HP bullets. It could help you narrow down the powder selection and hopefully get you a place to start.

Powder Start Max Velocity

RL-15 47.5gr - 56.9gr 3400fps
H4350 53.8gr - 60.1gr 3300fps
IMR 4350 56gr - 64.5gr 3400fps
Viht N-160 56.5gr - 66.7gr 3400fps

That's all the loads they list in the manual.

Have fun and be safe. I hope hop this helps,

Chris

 

[squirrelduster]

I worked up a load that seems to shoot really well, 54.2 grains of Varget over the 110 gr Accubond.
Shoots pretty well, normally 3/4" at 100 yards. Smokin right along about 3550 fps.

We need to see what happens when it hits something. I will keep you posted.

 

[bigngreen]

I'm going to drop-in on some 110 grainers after hunting season and work up some coyote medicine, I can't get 140 Bergers to open up on them. I saw some 110 v-max's yesterday but I was kinda wondering if they would hold up to WSM speeds or how much coyote will be left if they do hit. Might be messy

 

[Popapi]

Thanks Guys!!!!!!!!!!!!!!

 

[Popapi]

Have anyone tried RL19 with this bullet!?

 

[squirrelduster]

Have anyone tried RL19 with this bullet!?

I think that RE19 would be too slow for that bullet.

My dad did not get a buck this year with his new 270 WSM so hogs are next to see what happens with the new bullet.

 

[Iron Worker]

I have used Re#19 with the 110 V-Max. I couldn't get any coyote to cooperate with my plans. However in my Mod 70 I seated bullets to touching the lands and 68.1 was max. I was getting about 3,450 1"MOA at 100 yds. But now that I learn from this thread that Varget produced higher velocity ? That means I gotta take a scope off one rifle and put it back on my Mod 70. . I didn't know until now that Nosler even made a 110 Accubond for a 270. Now I gotta buy a box of them dudes . Then I guess I'll have to sight the rifle in. Find a coyote and kill him and take a picture to document the hole. Life is hard, at least I know I have 2 lbs of Varget hopefully I can find a varmint ?

 

[MontanaRifleman]

The Hodgdon site list loads for the Hornady 110 HP with 9 differnt powders

Cartridge Loads - Hodgdon Reloading Data Center - data.hodgdon.com

My go to powder for WSM's is RL17. Alliant list a max load for the 100 gr Speer HP at 67.5 gr. I would estimate the max for a 110 gr bullet to be about 2-3 gr less. I would start at a conservative 57 gr and work up 1/2 gr at a time, but that's just me. You could call Alliant and get info from them.

Alliant Powder - Reloader's Guide

Mark

 

[Popapi]

I worked up a load that seems to shoot really well, 54.2 grains of Varget over the 110 gr Accubond.
Shoots pretty well, normally 3/4" at 100 yards. Smokin right along about 3550 fps.

We need to see what happens when it hits something. I will keep you posted.

Have anyone else tried this Varget load!!!

 

[Iron Worker]

Yes I tried it out of my 24" Factory bbl. I clocked it at 3,325 average for 5 rnds. As hard as Varget is to come by I'll no longer use it in my 270 WSM. The good stuff is Re#17 66.5 produced 3,500. I've tried Re#19 H4350 and those were about 3,325 also ,but with heavier charges. .... Shooting 130 and above bullet weights Re#17 was to fast. Magpro, IMR 7828 Retumbo seem to do better.Hope this helps

 

[Popapi]

Yes I tried it out of my 24" Factory bbl. I clocked it at 3,325 average for 5 rnds. As hard as Varget is to come by I'll no longer use it in my 270 WSM. The good stuff is Re#17 66.5 produced 3,500. I've tried Re#19 H4350 and those were about 3,325 also ,but with heavier charges. .... Shooting 130 and above bullet weights Re#17 was to fast. Magpro, IMR 7828 Retumbo seem to do better.Hope this helps

Yes helped out a GREAT deal thanks for chiming in IW! I'll have to get some RE17!!!!

 

[Iron Worker]

Including tax's I paid $37 bucks for a LB of Re#17 yesterday.