Gun gun, New scope ran out of clicks

[Laker_Taker]

I bought a new gun from Sportsmans .243 SPS varminter. I bought a new scope 3200 bushnell 5-15. I had them mount it for me. I went to the range today and could not hit the target. Someone there had a lazer bore sighter and borrowed it to me. after playing with it I was three inches to the right of the bullseye. problem is I ran out of clicks to move it left. I removed the scope and loosend the dove tail bases and then I could sight it in. But when I tighten the bases it was off to the right again. Any suggestions on how to fix. I have had vertical problems on different rifles and a shim will correct it but never a horizontal.

Thanks Aaron

 

[davewilson]

if you're off that far i would go with the Burris signature Zee rings with the offset inserts. you have a lot of distortion and these rings won't put any stress on the scope tube.

 

[gun_rat82]

try leupold STD bases and rings, they'll give you all the windage adjustment you need. So will Weaver Grand-slam rings, but I would recommend the leupold STD bases over the weavers.

 

[JD338]

try leupold std bases and rings, they'll give you all the windage adjustment you need. So will weaver grand-slam rings, but i would recommend the leupold std bases over the weavers.

+1

jd338

 

[Laker_Taker]

I went to gander and bought the Leupold bases with the windage adjustments and everything is fine.

Thanks For all the replys

Aaron