Finaly got it all together and ready top shoot , even got the barrel broke in here at the house thanks to the suppressor , off for group testing shortly if the rain breaks.
Here are the specs
1)Phoenix Machine SA reciever , Heavy Rem tang , round target rear bridge and extended barrel tennon. Seekins .250" recoil lug with top key piece which also acts as a reoil lug for the scope base. Pacific Tool & Guage bolt polished .0015" under bolt race way diameter , M-16 Extractor and threaded bolt handel
2)Poilished and tuned Rem 40x trigger
3)Barlein 1-10 twist , Heavy palma conture , cut to 24" and muzzel threaded 5/8-24" with knurled nut , chambered with a Palma 95 reamer and throated for the 175gr Blak Hills factory ammo
4)Manners T4-A stock with butt spacer system , two fron studs , one rear stud , two flush cups on the left side , piller bedded with 7075 aluminum pillers and ALOT of devcon
5)Seekins 20 MOA scope rail
6)Badger M-5 bottom metal
7)The scope is a 3rd Gen IOR , 6-24x50mm with 35mm tube and IOR V-tac rings
8)The suppressor in the pic is a form 1 can one that I made for this gun , it uses stepped cone-spacer setp with a fully welded baffelstack and end caps , an outer tube is then press fit over the core and the end caps welded out , the bullet hole is then reamed and the rear threaded at the same setup hand fitted to this barrel,though a bit heavier and bigger than most comercial cans it works as well of better that the best out their.
Special thanks to Nathan Dagley for building this rig for me and putting up with me since I've found out about him (that says alot about his patience
) His work on this gun as well as all others I've seen from him is second to none.This rifle will serve me and its comunity well I'm certain !!