Long Range Hunting Online Magazine

Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Gunsmithing


Shilen DGA

LinkBack Thread Tools Display Modes
Unread 12-08-2013, 07:28 PM
Bronze Member
Join Date: Dec 2009
Location: Hudson, NC
Posts: 39
Shilen DGA

I just bought a Shilen DGA action with a 223 bolt face. However, the bolt is not equipped with an ejector, even though there is a hole in the bolt face for one. Will the ejector plunger, ejector spring, and roll pin for the Remington Model 700 work in the DGA bolt?
Reply With Quote

Unread 12-09-2013, 09:18 AM
Platinum Member
Join Date: Apr 2003
Location: North Bend, Oregon
Posts: 1,394
Re: Shilen DGA

The Remington parts will most likely fit. If not these parts are simple to make. I use drill stock (old drill bits) or stainless tig rod to make the pins and then cut a spring from a Brownells spring assortment.

If the gun is a varmint or mainly a target use rifle I kind of like them without an ejector. I have a Bat action on my bench right now for a Chey Tac single shot hunting rifle and the bolt face is not even drilled for an ejector.
Build a man a fire and you heat him for a day.
Set him on fire and you heat him for life.

Only accurate rifles are interesting.

Gordy and Brady.
Reply With Quote


Thread Tools
Display Modes

All times are GMT -5. The time now is 07:30 AM.

Powered by vBulletin ©2000 - 2015, Jelsoft Enterprises Ltd.
Content Management Powered by vBadvanced CMPS
All content ©2010-2014 Long Range Hunting, LLC