Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Gunsmithing


Reply

Savage bedding question

 
LinkBack Thread Tools Display Modes
  #1  
Old 12-26-2010, 12:14 AM
Junior Member
 
Join Date: Oct 2010
Location: KS
Posts: 4
Savage bedding question

I've been reading some articles on bedding. Thought I would make my first attempt on my Savage model 10 in .243. I took it apart and the magazine stays with the stock. There is also a metal flange between the stock and action at the rear action screw. Haven't seen anything on how to deal with or not to mess with this style of stock. Maybe I should just bed the recoil lug and around the front screw? Any tips would be appreciated. Thanks
Reply With Quote
  #2  
Old 12-26-2010, 12:32 PM
Platinum Member
 
Join Date: Nov 2008
Location: SW Montana
Posts: 4,553
Re: Savage bedding question

I cut the tab off and then remove the box after that with a needle nose plier. I've bedded right over the top of it then carefully cut out the material over it but that leaves the bedding so thin on the RH side that it chips very easy, after a couple times of that I cut of the tang on the bracket and all is well. If the lower part of the tang doesn't fell like it will hold the box you just bend the spur out till you have to push the box in place. Make sure that the tang is free floated what ever you do on a Savage.
__________________
High Fence, Low Fence, Stuck in the Fence, if I can Tag it and Eat it, it's Hunting!

"Pain is weakness leaving your body"
Reply With Quote
  #3  
Old 12-28-2010, 07:19 PM
Silver Member
 
Join Date: Sep 2002
Location: Nebraska
Posts: 264
Re: Savage bedding question

If bedded right (stress free) bedding the tang will not matter.

I have bedded both of my savages with the tang and shoot lights out.
My 260, it shot close to moa at 200. Bedded it and with the same load it now shoots 5/8"-3/4" at 200.

Just bedded my 7wsm and got a chance to test some loads with it at 130 yards( horses are still in my usual spot). I have 4 loads across a 1 grain spread that have 1/4" vertical and less than an inch horizontal. The horizontal is more me and some wind. Wind was blowing 20mph. Plus i have a cheapo millet on it now till my viper comes in.

If you bed the tang and find a good load then turns to crap you can always take the bedding out from under the tang to see if it helps.
__________________
Matt
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes


Similar Threads for: Savage bedding question
Thread Thread Starter Forum Replies Last Post
A bedding question squirrelduster Gunsmithing 6 02-12-2010 07:33 PM
Bedding question shadowdrak Gunsmithing 9 08-12-2008 07:22 AM
Another Savage, another bedding question, another newb... Forester Gunsmithing 6 04-08-2008 12:31 AM
Rem 700 Bedding question......need help Curt Equipment Discussions 8 04-02-2006 01:02 PM
bedding question/Primer Question larryaguilar Rifles, Bullets, Barrels & Ballistics 7 03-01-2003 12:10 AM


All times are GMT -5. The time now is 08:05 AM.


Powered by vBulletin ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Management Powered by vBadvanced CMPS
All content ©2010-2014 Long Range Hunting, LLC