Long Range Hunting Online Magazine

Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Gunsmithing


Remington 700 bolt failure

LinkBack Thread Tools Display Modes
Unread 11-10-2008, 09:04 PM
Bronze Member
Join Date: Dec 2004
Location: PEI Canada
Posts: 72
Re: Remington 700 bolt failure

accu-tig.com is highly recommended, obviously he Tig welds the handles on properly.
Reply With Quote

Unread 11-11-2008, 05:37 AM
Silver Member
Join Date: May 2007
Posts: 252
Re: Remington 700 bolt failure

I've had that happen twice. All I did was use a propane torch (with the bolt striped) and some silver solder from the local NAPA store. After that just clean everthing up and reassemble the bolt and start shooting.

Good Luck

Reply With Quote
Unread 11-26-2008, 01:43 PM
Junior Member
Join Date: Nov 2008
Location: Fairbanks,AK.
Posts: 4
Re: Remington 700 bolt failure

I prefer to TIG weld handles.
Handle location & timing can be held to tighter tolerances with heat transfer & clean up being non existent.
Reply With Quote


Thread Tools
Display Modes

Similar Threads for: Remington 700 bolt failure
Thread Thread Starter Forum Replies Last Post
Brass Failure 101sniper Reloading 13 03-10-2011 10:31 AM
primer failure dieseldoc Reloading 12 01-13-2011 12:58 PM
remington S/A bolt wsm bolt face jacack Gun Parts - Stocks, Barrels, Actions, etc. 5 01-04-2011 12:11 AM
Remington bolt handle failure mdrewel Long Range Hunting & Shooting 10 11-06-2006 08:26 AM
Wanted REAL BAD Remington short action Bolt with a 308 bolt face Darryl Cassel Guns For Sale 4 07-23-2002 04:24 PM

All times are GMT -5. The time now is 07:26 PM.

All content ©2010-2015 Long Range Hunting, LLC