Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Gunsmithing


Reply

Question re butt pad on Remington 700 Sendero II

 
LinkBack Thread Tools Display Modes
  #1  
Old 01-13-2013, 02:05 PM
Junior Member
 
Join Date: Nov 2012
Location: Wyoming
Posts: 26
Question re butt pad on Remington 700 Sendero II

I have a Remington 700 Sendero II in .300 Win Mag. I have been thinking about replacing the factory butt pad with a Limbsaver butt pad. However, the factory buttpad does not appear to be attached to the factory HS Precision stock using screws. At least, no screw holes are visible in the butt pad.

So, can the factory butt pad be replaced? What is involved with replacing it? Do I just cut off the factory butt pad and glue on the replacement? Should I just get a muzzle brake instead?

Thanks.
Reply With Quote
  #2  
Old 01-14-2013, 12:20 PM
Official LRH Sponsor
 
Join Date: Dec 2006
Location: Utah
Posts: 125
Re: Question re butt pad on Remington 700 Sendero II

Replacing butt pads is not always as straight forward as it seems but H&S butt are glued on at least the ones I have done. Your probably better off to get it cold and with care and a good putty knife break off the old pad and then you can fit another and attach it. Filler is sometimes needed because the core of the stock is to soft to hold screws or you can epxoy the fitted pad.

Good Luck
Steve
__________________
Steve

Elk Meadow Performance
www.elkmeadowperformance.com
Reply With Quote
  #3  
Old 01-14-2013, 07:31 PM
Silver Member
 
Join Date: Apr 2007
Location: Fort Morgan, Colorado
Posts: 328
Re: Question re butt pad on Remington 700 Sendero II

I had an original Sendero SF chambered in 338RUM and the original Decelerator pad's glue came loose without my knowing it and that rifle liked to have kicked me into another county. I finally figured out the Decelerator uses air which is compressed under it when the gun is fired to slow recoil and with the glue loosening it allowed the air to release. I went to the hardware store and bought a couple of appropriate screws and remounted it without any problem. I had to drill through the pad to install the screws.
__________________
Dennis
Reply With Quote
  #4  
Old 01-14-2013, 07:43 PM
Junior Member
 
Join Date: Nov 2012
Location: Wyoming
Posts: 26
Re: Question re butt pad on Remington 700 Sendero II

sj-pratt and gunpoor,

Thanks for the information. I always prefer to know what I'm getting into before I start removing things installed by the manufacturer.
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes



All times are GMT -5. The time now is 04:35 AM.


Powered by vBulletin ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Management Powered by vBadvanced CMPS
All content ©2010-2014 Long Range Hunting, LLC